Configuring The Tcp Or Udp Port Range On The Scopia Xt Server For Ip Office - Avaya RADVISION Scopia XT5000 Installation Manual

Configuring the TCP or UDP Port Range on the Scopia XT Server
for IP Office
About this task
You can configure the TCP or UDP port range by setting the base port, which is the lower end of the port
range (if, for example, port 3230 is busy).
The Scopia XT Server for IP Office uses dynamic TCP ports 3230-3248 for the following:
• H.225.0: An H.323 protocol that specifies the messages and procedures used by gatekeepers to
set up calls.
• Q.931:A telephony protocol used for establishing and terminating the connection in H.323 calls.
• H.245: A Control Protocol used for multimedia communication; enables transferring information
about the device capabilities, as well as opening/closing the logical channels that carry media
streams.
• SIP: A signaling protocol used for creating, modifying, or terminating multimedia connections
between two or more participants.
The Scopia XT Server for IP Office uses dynamic UDP ports 3230-3248 for enabling real-time H.323
and SIP media, including audio, video, and H.224/data (RTP), and media control (RTCP).
Procedure
1. Access the port settings as follows:
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
• From the web interface, select Administrator Settings > Networks > Preferences >
Dynamic Ports.
• From the endpoint interface, select Configure > Advanced > Networks >
Preferences > Dynamic Ports.
Planning the Topology of the Scopia XT Server for IP Office
Deployment | 21