Avaya RADVISION Scopia XT5000 Installation Manual page 82

Perform this procedure to enable your Scopia XT Server for IP Office to traverse NAT and firewall. For
an explanation about NAT and firewall approaches, as well as examples of deployments, see
NAT and Firewall Traversal with Scopia XT Server for IP Office
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint
Procedure
1. Access the network settings as follows:
2. Set the fields as described in
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
• From the XT Server web interface, select Administrator Settings > Networks >
Preferences > NAT.
• From the endpoint's main menu, select Configure > Advanced > Networks >
Preferences > NAT.
Figure 47: Configuring NAT traversal settings from the web interface
Table 22: Configuring NAT-related settings
Field Name
NAT Traversal Set to Yes to allow the system to be located behind a firewall/NAT.
Set to No if the system is not located behind a firewall/NAT, but has a
public IP address.
NAT Discovery Manual method of setting the system's firewall/NAT public IP
address. Enter the Public IP address for that setting.
HTTP discovery - This method uses a Radvision HTTP server to
discover the presence of a firewall/NAT and its public IP address
(requires the endpoint to have internet access).
STUN discovery - This method uses a public STUN server to
discover the presence of a firewall/NAT and its public IP address.
This is the suggested method.
on page 14.
on page 45.
Table 22: Configuring NAT-related settings
Description
Planning
on page 82.
Initial Configuration | 82