Chapter 5: Setting Up The Scopia Xt Server For Ip Office; Mounting The Xt Codec Unit; Connecting Scopia Xt Server For Ip Office To Your Network - Avaya RADVISION Scopia XT5000 Installation Manual

Chapter 5 | Setting up the Scopia XT Server
After reading the section
IP Office. These sections describe how to install the XT Codec Unit and connect its accessories:
Navigation
•

Mounting the XT Codec Unit

•

Connecting Scopia XT Server for IP Office to Your Network

•
Connecting a Monitor to the XT Server
•
Installing the Batteries of the XT Remote Control Unit
Mounting the XT Codec Unit
About this task
Follow the guidelines in this section to correctly place the XT Codec Unit.
Procedure
Connecting Scopia XT Server for IP Office to Your Network
About this task
Your Scopia XT Server for IP Office has two GLAN 10/100/1000 ports for connecting to the network.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
for IP Office
Prerequisites for Setting up the System
on page 24
on page 25
Place the XT Codec Unit following these guidelines:
• Place the XT Codec Unit on a horizontal surface which stands firmly on its base.
• The surface must be dry and free of dust, oil and other residues.
• Leave enough space for air circulation and for connecting cables easily.
• Place the XT Codec Unit anywhere within 5 meter reach of the camera cables.
Caution:
Do not place the camera on top of the XT Codec Unit. It can cause the system to overheat.
on page 23, you can install the Scopia XT Server for
on page 24
on page 26
Setting up the Scopia XT Server for IP Office | 24