Configuring Network Settings - Avaya RADVISION Scopia XT5000 Installation Manual

5. Use the arrow keys on the XT Remote Control Unit to position the image, and then press
6. To configure network settings, select Next and continue with

Configuring Network Settings

About this task
This procedure describes how to set up the network settings and the IP address the system uses for
placing a call.
If you are modifying the network settings after initial setup, navigate to Configure > Network > GLAN 1
from the Main menu. For more information, see
Before you begin
This procedure is performed as part of the Quick Setup Wizard, after
page 56. Consult with your network administrator to configure these fields.
Access the quick setup wizard from the endpoint or web interface, as described in
Setup Procedure
Procedure
1. Press ok/menu and select one of the following from the IP Address Mode list:
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
ok/menu.
on page 58.
on page 53.
• Automatic: (Default) Select this option if the system gets its IP address automatically
(using DCHP).
The IP address, Subnet mask, Gateway, and DNS fields appear as read-only. See
Table 12: Configuring IP addresses
• Manual: Select this option if you require a static IP address. We recommend this option
since external endpoints need to dial to this endpoint as an MCU. Enter the fields as
described in Table 12: Configuring IP addresses
To secure SIP connections using TLS certificates, your system must have a static IP
address, since the system generates the certificate request using its IP address as the
Common Name (CN). For more information, see
Server Using TLS on page 88.
Configuring Network Settings
Configuring GLAN Use on page 77.
Adjusting the Image Position
on page 59 for a description of these fields.
on page 59.
Securing Connections to the XT
on
Accessing the Quick
Initial Configuration | 58