Setting The Time Zone - Avaya RADVISION Scopia XT5000 Installation Manual

3. From the web interface only, select Save.

Setting the Time Zone

About this task
You can set the time zone from your endpoint or the XT Server web interface.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint
Procedure
1. Access the time zone settings as follows:
2. Configure settings as described in
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Field Name
Internet time Select Yes to synchronize the system clock with the network clock,
thus allowing you to align devices connected to the Internet using
NTP.
Use Default NTP If your organization uses an external Network Time Protocol (NTP)
Server server for synchronizing the system clock, select Yes. If your
organization uses one or two internal NTP servers for that purpose,
select No and enter the server IP address in fields Server 1 and/or
Server 2.
Refresh time Indicates the period of time after which the system contacts the NTP
server to refresh the clock.
• From the XT Server web interface, select Administrator Settings > System > Date &
Time > Time Zone.
• From the endpoint's main menu, select Configure > Advanced > System > Date &
Time > Time Zone.
You need to enter the PIN required to access the Advanced settings. The default PIN
is 1234.
74.
Description
on page 45.
Table 18: Configuring time zone related settings on page
Initial Configuration | 73