Table of Contents
Advertisement
Step 10. Make sure that the green power LEDs on the power supply are lit, indicating that the power supply
is operating correctly.
Step 11. If you are replacing a power supply with one of a different wattage in the server, apply the new
power information label provided over the existing power information label on the server. Power
supplies in the server must be with the same power rating or wattage to ensure that the server
will operate correctly.
Figure 4. Power information label
Step 12. If you are adding a power supply to the server, attach the redundant power information label that
comes with this option on the server cover near the power supplies.
Figure 5. Redundant power information label
Installing a USB embedded hypervisor flash device
Use this information to install a USB embedded hypervisor flash device.
Hypervisor is a virtualization platform that enables multiple operating systems to run on a host computer at
the same time. Support for hypervisor is available with the purchase and installation of an optional USB
hypervisor memory key, with embedded hypervisor software.
To install the USB hypervisor memory key, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 36.
Step 2.
Turn off the server (see "Turning off the server" on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3.
Remove the top cover (see "Removing the server top cover" on page 39).
Step 4.
If you have the optional hot-swap rear hard disk drive cage installed, rotate it up (see "Rotating the
optional hot-swap rear hard disk drive cage up" on page 40).
.
Chapter 2
Installing optional devices
85
Advertisement
Table of Contents
Troubleshooting
