Installing A Usb Embedded Hypervisor Flash Device; Replacing The Virtual Media Key; Removing The Virtual Media Key - Lenovo ThinkServer TS200 Hardware Maintenance Manual

Installing a USB embedded hypervisor flash device

To install the hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page "Important Safety Information" on page 1.
2. Turn off the server and all attached devices; then, disconnect all power cords.
3. Unlock and remove the side cover (see "Removing the side cover" on page 142).
4. Unlock the USB retaining latch by squeezing the two retaining clips toward each other.
5. Align the flash device with the connector on the system board and push it into the connector until it
is firmly seated.
6. Press down on the retaining latch to lock the flash device into the USB connector.
7. Go to "Completing the FRU replacement" on page 200.

Replacing the virtual media key

Use the following procedures to replace the virtual media key.

Removing the virtual media key

To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page "Important Safety Information" on page 1.
2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the side cover
(see "Removing the side cover" on page 142).
3. Grasp the virtual media key and gently slide it up and off of the mounting tab.
172
Hardware Maintenance Manual