Table of Contents
Advertisement
Step 10. Make sure that the green power LEDs on the power supply are lit, indicating that the power supply
is operating correctly.
Step 11. If you are replacing a power supply with one of a different wattage in the server, apply the new
power information label provided over the existing power information label on the server. Power
supplies in the server must be with the same power rating or wattage to ensure that the server
will operate correctly.
Figure 53. Power information label
Step 12. If you are adding a power supply to the server, attach the redundant power information label that
comes with this option on the server cover near the power supplies.
Figure 54. Redundant power information label
Installing a USB embedded hypervisor flash device
Use this information to install a USB embedded hypervisor flash device.
To install a USB hypervisor flash device, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see "Removing the cover" on page 37).
Step 4.
Remove PCI riser-card assembly 2 (see "Removing a PCI riser-card assembly" on page 221).
Step 5.
Install the flash device:
.
Chapter 2
Installing optional devices
69
Advertisement
Table of Contents
Troubleshooting
