Installing A Usb Embedded Hypervisor Flash Device - Lenovo x3250 m6 Installation And Service Manual

Step 6. Slide the lock bar on the flash device connector to the unlocked position and pull the USB flash
device out of the connector.
Figure 50. USB embedded hypervisor flash device removal
Step 7. Complete the parts replacement. See "Completing the parts replacement" on page 172.

Installing a USB embedded hypervisor flash device

To install a USB embedded hypervisor flash device, do the following:
Step 1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
Step 2. Remove the server cover. See "Removing the server cover" on page 88.
Step 3. Remove the air baffle. See "Removing the air baffle" on page 90.
Step 4. Remove the PCI riser-card assembly. See "Removing the PCI riser-card assembly" on page 93.
Step 5. Locate the USB embedded hypervisor flash device connector on the system board. See
"System-board connectors" on page 21.
118
Lenovo System x3250 M6 Installation and Service Guide