Removing A Pci Riser-Card Assembly - Lenovo x3550 M5 Installation And Service Manual

Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2. Turn off the server, and disconnect all power cords and external cables.
Step 3. Remove the cover (see "Removing the cover" on page 119).
Step 4. Remove PCI riser-card assembly 2 (see "Removing a PCI riser-card assembly" on page 169).
Step 5. Insert the SD cards into the SD adapter.
Step 6. Align the SD adapter with the alignment pins and connector; then, push downwards until it
is firmly seated.
Step 7. Fasten the two screws.
Connector
Figure 88. SD adapter installation
Step 8. Reconnect the power cords and any cables that you removed.
Step 9. Reinstall the cover (see "Replacing the cover" on page 120).
Step 10. Slide the server into the rack.
Step 11. See the http://www.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5096845, that
comes with the option, for information about how to configure the SD adapter.
Step 12. Turn on the peripheral devices and the server.

Removing a PCI riser-card assembly

Use this information to remove a PCI riser-card assembly.
Note: PCI riser-card brackets must be installed even if you do not install an adapter.
To remove a PCI riser-card assembly, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
Step 3. Remove the cover (see "Removing the cover" on page 119).
SD 2
4
4
3
Alignment Pin
1
SD 1
SD Adapter
.
Chapter 5 Removing and replacing components
169