Displaying Information For Breakout Ports - Brocade Communications Systems FastIron Administration Manual

device# Flash Memory Write (8192 bytes per dot) .
Copy Done.

Displaying information for breakout ports

Use the show breakout command to display breakout port status.
The show breakout command indicates which ports are configured for breakout and which breakout
ports are in operation. The command also displays ports that have been configured for breakout but that
are not yet broken out into sub-ports, pending reload.
The following example displays breakout port information for an ICX 7750-48F.
Port 1/2/1 is the only port with active sub-ports; however, ports 1/2/2 and 1/2/4
are configured for breakout, pending reload.
Device# show breakout
Unit-Id: 1
Port
1/2/1
1/2/2
1/2/3
1/2/4
1/2/5
1/2/6
1/3/1
1/3/2
1/3/3
1/3/4
1/3/5
1/3/6
FastIron Ethernet Switch Administration Guide
53-1003625-01
Module Exist Module Conf
yes no
yes no
yes no
yes no
yes no
yes no
yes no
yes no
yes no
yes no
yes no
yes no
Displaying information for breakout ports
Breakout-config Breakout-oper
yes yes
yes no
no no
yes no
no no
no no
no no
no no
no no
no no
no no
no no
383