Displaying Oam Information - Brocade Communications Systems FastIron Administration Manual

Displaying OAM information

You can set the operational mode of EFM-OAM as Active or Passive.
• Enter the ethernet stackid/slot/port active command to set the EFM-OAM operational mode as
• Enter the ethernet stackid/slot/port to stackid/slot/port active command to set the EFM-OAM
• Enter the ethernet stackid/slot/port passive command to set the EFM-OAM operational mode as
• Enter the ethernet stackid/slot/port to stackid/slot/port passive command to set the EFM-OAM
6. (Optional) Enter the ethernet stackid/slot/port allow-loopback command to enable the interface to
respond to a loopback request from the remote device.
device(config-link-oam)# ethernet 1/1/3 allow-loopback
7. (Optional) Enter the ethernet stackid/slot/port remote-failure command to set the device for the
remote-failure action to be taken upon the reception of critical event information on the interface.
device(config-link-oam)# ethernet 1/1/3 remote-failure critical-event action
block-interface
8. (Optional) Enter the remote-loopback ethernet stackid/slot/port command to start or stop the
remote loopback procedure on a remote device.
device(config-link-oam)# remote-loopback ethernet 2/1/1 start
device(config-link-oam)# remote-loopback ethernet 2/1/1 stop
The following output shows an example of EFM-OAM configuration.
device# configure terminal
device(config)# link-oam
device(config-link-oam)# timeout 5
device(config-link-oam)# pdu-rate 2
device(config-link-oam)# ethernet 1/1/3 active
device(config-link-oam)# ethernet 1/1/3 allow-loopback
device(config-link-oam)# remote-loopback ethernet 2/1/1 start
device(config-link-oam)# ethernet 1/1/3 remote-failure critical-event action block-
interface
Displaying OAM information
The following sample output of the show link-oam info command displays the OAM information on all
OAM-enabled ports.
device (config)# show link-oam info
Ethernet Link Status
1/1/1
1/1/2
1/1/3
1/1/4
1/1/5
1/1/6
1/1/7
The following sample output of the show link-oam info detail command displays detailed OAM
information on all OAM-enabled ports.
device(config)# show link-oam info detail
OAM information for Ethernet port: 10/1/1
118
active on an interface.
device(config-link-oam)# ethernet 1/1/3 active
device(config-link-oam)# ethernet 1/1/4 active
operational mode as active on a range of interfaces.
device(config-link-oam)# ethernet 1/1/5 to 1/1/8 active
passive on an interface.
device(config-link-oam)# ethernet 2/1/1 passive
operational mode as passive on a range of interfaces.
device(config-link-oam)# ethernet 2/1/1 to 2/1/8 passive
OAM Status
up up
up up
up up
up init
down down
down down
down down
+link-oam mode:
+link status:
+oam status:
Local information
multiplexer action:
Mode Local Stable
active
passive
active
passive unsatisfied
passive
passive
passive
passive
down
down
forward
FastIron Ethernet Switch Administration Guide
Remote Stable
satisfied satisfied
satisfied satisfied
satisfied satisfied
unsatisfied
unsatisfied unsatisfied
unsatisfied unsatisfied
unsatisfied unsatisfied
53-1003625-01