Brocade Communications Systems FastIron Administration Manual page 261

TABLE 37
Parameter
sFlow version
sFlow services
sFlow agent IP address
sFlow source IP address
sFlow source IPv6
address
Collector
Configured UDP source
port
Polling interval
Configured default
sampling rate
Actual default sampling
rate
Sample mode
The maximum sFlow
sample size
exporting cpu-traffic
FastIron Ethernet Switch Administration Guide
53-1003625-01
sFlow information
Definition
The version of sFlow enabled on the device, which can be one of the following:
• 2
• 5
The feature state, which can be one of the following:
• disabled
• enabled
The IP address that sFlow is using in the agent_address field of packets sent to the
collectors. Refer to
The IPv4 address that sFlow is using as the source IP address in the sFlow datagram.
The IPv6 address that sFlow is using as the source IP address in the sFlow datagram.
The collector information. The following information is displayed for each collector:
• IP address
• UDP port
If more than one collector is configured, the line above the collectors indicates how
many have been configured.
The UDP source port used to send data to the collector.
The port counter polling interval.
The configured global sampling rate. If you changed the global sampling rate, the value
you entered is shown here. The actual rate calculated by the software based on the
value you entered is listed on the next line, "Actual default sampling rate".
The actual default sampling rate.
Indicates whether only the non-dropped packets or all the packets, including the
dropped packets, are included for sFlow sampling.
The maximum size of a flow sample sent to the sFlow collector.
Indicates whether or not the sFlow agent is configured to export data destined to the
CPU (e.g., Telnet sessions) to the sFlow collector:
• enabled
• disabled
sFlow and agent address on page 247.
Network Monitoring
261