Example For Setting The Ipv4 Hitless Purge Timer On The Non-Default Vrf; Setting The Ipv6 Hitless Purge Timer On The Defatult Vrf; Example For Setting The Ipv6 Hitless Purge Timer On The Defatult Vrf; Setting The Ipv4 Hitless Purge Timer On The Non-Default Vrf - Brocade Communications Systems FastIron Administration Manual

Example for setting the IPv4 hitless purge timer on the non-default VRF

Example for setting the IPv4 hitless purge timer on the non-default
VRF
The following example shows how to set the IPv4 purge timer on the non-default VRF:
Brocade(config)# vrf blue
Brocade(config-vrf-blue)# rd 10:10
Brocade(config-vrf-blue)# address-family ipv4
Brocade(config-vrf-blue-ipv4)# ip hitless-route-purge-timer 60

Setting the IPv6 hitless purge timer on the defatult VRF

To configure the purge timer, enter the ipv6 hitless-route-purge-timer command in global
configuration mode.

Example for setting the IPv6 hitless purge timer on the defatult VRF

The following example shows how to set the IPv6 hitless purge timer on the default VRF:
Brocade(config)# ipv6 hitless-route-purge-timer 60

Setting the IPv4 hitless purge timer on the non-default VRF

Before you begin: Enable IPv6 unicast routing using the ipv6 unicast-routing command in global
configuration mode.
1. Enter the VRF configuration mode using the vrf command.
2. Configure route distinguisher using the rd command.
3. Enter the IPv6 address family configuration mode using the address-family ipv6 command.
4. Configure the router purge timer using the ipv6 hitless-route-purge-timer command.
Example for setting the IPv6 hitless purge timer on the non-default
VRF
The following example shows how to set the IPv6 purge timer on the non-default VRF:
Brocade(config)# vrf blue
Brocade(config-vrf-blue)# rd 10:10
Brocade(config-vrf-blue)# address-family ipv6
Brocade(config-vrf-blue-ipv4)# ipv6 hitless-route-purge-timer 60

Energy Efficient Ethernet

Energy Efficient Ethernet (EEE) regulates and saves power consumed by the active hardware
components in the switch and conserves power during idle time.
EEE allows Brocade devices to conform to green computing standards. This functionality is achieved
by moving the data ports to a low-power state when their function is not necessary or when they are in
134 FastIron Ethernet Switch Administration Guide
53-1003625-01