Brocade Communications Systems FastIron Administration Manual page 111

Error
code
18
19
20
21
22
23
This section describes the error messages associated with the TFTP transfer of PoE firmware file to a
Brocade device.
Message
Firmware TFTP timeout.
Firmware is not valid for this
platform.
Firmware is not valid for the
IEEE 802.3at (PoE-Plus)
controller type.
Firmware is not valid for the
IEEE 802.3af PoE controller
type.
Firmware type cannot be
detected from the firmware
content.
TFTP File not Valid for PoE
Controller Type.
Firmware tftp remote file
access failed.
FastIron Ethernet Switch Administration Guide
53-1003625-01
Message Explanation and action
TFTP remote - access
violation.
TFTP remote - disk full.
TFTP remote - illegal
operation.
TFTP remote - unknown
transfer ID.
TFTP remote - file
already exists.
TFTP remote - no such
user.
Explanation and action
TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is running.
Each PoE firmware file delivered by Brocade is meant to be used on the specific
platform only. If the file is used on a platform for which it is not meant, then this error
message will display.
Download the correct file, then retry the transfer.
Each PoE firmware file delivered by Brocade is meant to be used on the specific
platform only. If the file is used on a platform for which it is not meant, then this error
message will display.
Download the correct file, then retry the transfer.
Each PoE firmware file delivered by Brocade is meant to be used on the specific
platform and the specific PoE controller on the specified module. If the file is used for
a platform for which it is meant, but the PoE controller is not same then this error
message will display.
Download the correct file, then retry the transfer.
The TFTP server needs read access on the PoE firmware file. Check the
permissions on the file, then try again.
Operations, Administration, and Maintenance
111