Power over Ethernet
TABLE 45
Column
Cumulative port state data
NOTE
When you enable a port using the CLI, it may take 12 or more seconds before the operational state of that port is
displayed correctly in the show inline power output.
Slot
#Ports Admin-On
#Ports Admin-Off
#Ports Oper-On
#Ports Oper-Off
#Ports Off-Denied
#Ports Off-No-PD
#Ports Off-Fault
Total
Cumulative port power data
Slot
#Ports Pri: 1
#Ports Pri: 2
#Ports Pri: 3
Power Consumption
Power Allocation
370
Field definitions for the show inline power detail command (Continued)
Definition
The Interface device/slot/port number.
The number of ports on the Interface module on which the inline power command
was issued.
The number of ports on the Interface module on which the inline power command
was not issued.
The number of ports on the Interface module that are receiving inline power from
the PoE power supply.
The number of ports on the Interface module that are not receiving inline power
from the PoE power supply.
The number of ports on the Interface module that were denied power because of
insufficient power.
The number of ports on the Interface module to which no PDs are connected.
The number of ports on the Interface module that are not receiving power because
of a subscription overload.
The totals for all of the fields in the Cumulative Port State Data report.
The device/slot/port number.
The number of PoE ports on the Interface module that have a PoE port priority of 1.
The number of PoE ports on the Interface module that have a PoE port priority of 2.
The number of PoE ports on the Interface module that have a PoE port priority of 3.
The total number of watts consumed by PoE power consuming devices, plus any
cable loss.
The number of watts allocated to the Interface module PoE ports. This value is the
sum of the ports' default or configured maximum power levels, or power classes
automatically detected by the FastIron PoE device.
FastIron Ethernet Switch Administration Guide
53-1003625-01
Need help?
Do you have a question about the FastIron and is the answer not in the manual?