Specifying An Ipv6 Host As An Snmp Trap Receiver; Viewing Ipv6 Snmp Server Addresses - Brocade Communications Systems FastIron Administration Manual

Restricting SNMP Access to an IPv6 Node
Restricting SNMP Access to an IPv6 Node
You can restrict SNMP access so that the Brocade device can only be accessed by the IPv6 host
address that you specify. To do so, enter a command such as the following .
device(config)#snmp-client ipv6 2001:DB8:89::23
Syntax: snmp-clientipv6 ipv6-address
The ipv6-address must be in hexadecimal format using 16-bit values between colons as documented
in RFC 2373.

Specifying an IPv6 host as an SNMP trap receiver

You can specify an IPv6 host as a trap receiver to ensure that all SNMP traps sent by the Brocade
device will go to the same SNMP trap receiver or set of receivers, typically one or more host devices
on the network. To do so, enter the snmp-server host ipv6 command .
device(config)#snmp-server host ipv6 2001:DB8:89::13
Syntax: snmp-serverhost ipv6 ipv6-address
The ipv6-address must be in hexadecimal format using 16-bit values between colons as documented
in RFC 2373.

Viewing IPv6 SNMP server addresses

Many of the existing show commands display IPv6 addresses for IPv6 SNMP servers. The following
example shows output for the show snmp server command.
device#show snmp server
Community(ro): .....
Traps
Total Trap-Receiver Entries: 4
Trap-Receiver IP-Address
158
Contact:
Location:
Warm/Cold start: Enable
Link up: Enable
Link down: Enable
Authentication: Enable
Locked address violation: Enable
Power supply failure: Enable
Fan failure: Enable
Temperature warning: Enable
STP new root: Enable
STP topology change: Enable
vsrp: Enable
1 10.147.201.100
162 .....
2 2001:DB8::200
3 10.147.202.100
162 .....
4 2001:DB8::200
Port-Number Community
162 .....
162 .....
FastIron Ethernet Switch Administration Guide
53-1003625-01