How Command Information Is Presented In This Guide - Brocade Communications Systems FastIron Administration Manual

How command information is presented in this guide

TABLE 1
Feature
ICX 7750 40 Gbps
breakout port
configuration
Energy efficient
ethernet
External USB hotplug
Histogram
IEEE 802.3ah EFM-
OAM
sFlow sample mode
sFlow source IP
address
Flash timeout
Elapsed timestamp
display for port statistics
reset
How command information is presented in this guide
For all new content supported in FastIron Release 08.0.20 and later, command information is
documented in a standalone command reference guide.
In an effort to provide consistent command line interface (CLI) documentation for all products, Brocade
is in the process of completing a standalone command reference for the FastIron platforms. This
16
Summary of enhancements in FastIron release 08.0.30
Description
Certain ICX 7750 40 Gbps ports can be
configured with sub-ports when a breakout
cable is installed.
Regulates and saves power consumed by the
active hardware components in the switch and
conserves power during idle time. This feature
is supported on the ICX 7250 and ICX 7450
devices.
Allows you to copy images, cores, logs and
configurations between the external USB and
the internal eUSB. This feature is supported on
ICX 7250, ICX 7450 and ICX 7750 devices.
The histogram framework feature monitors and
records system resource usage information.
This feature is supported on ICX 6430, ICX
6450, ICX 7250, ICX 7450 and ICX 7750
devices.
EFM-OAM provides mechanisms to monitor link
operation, health and improve fault isolation of
Ethernet network to increase management
capability.
The sample mode can be changed to include
the dropped packets for sFlow sampling.
The sFlow source interface can be configured
from which the IP source address is selected for
the sFlow datagram.
The flash timeout can be configured to a value
from 12 through 60 minutes.
The elapsed time between the most recent
reset of the port statistics counters and the time
when the show statistics command is
executed, can be displayed in the output of the
show statistics command.
Described in
Refer to the chapter 40 Gbps
Breakout Ports for configuration
information. Refer to the ICX 7750
Ethernet Switch Hardware Installation
Guide for information on the breakout
cable.
Refer to the chapter Operations
Administration and Maintenance
Refer to the chapter Operations
Administration and Maintenance
Refer to the chapter Operations
Administration and Maintenance
Refer to IEEE 802.3ah EFM-OAM
page 114
Refer to Changing the sampling
mode on page 251
Refer to sFlow and source IP address
on page 248
Refer to Flash timeout on page 94
Refer to Enabling the display of the
elapsed timestamp for port statistics
reset on page 231
FastIron Ethernet Switch Administration Guide
on
53-1003625-01