Cli Commands For Use With The Management Port - Brocade Communications Systems FastIron Administration Manual

Ethernet switch
Table of Contents

Advertisement

CLI Commands for use with the management port

management port. In this situation, the MAC address of the old Active Controller and the MAC address
of the new controller will be different.
CLI Commands for use with the management port
The following CLI commands can be used with a management port.
To display the current configuration, use the show running-config interface management
command.
Syntax: show running-config interface management num
device(config-if-mgmt)# ip addr 10.44.9.64/24
device(config)# show running-config interface management 1
interface management 1
ip address 10.44.9.64 255.255.255.0
To display the current configuration, use the show interfaces management command.
Syntax: show interfaces management num
device(config)# show interfaces management 1
GigEthernetmgmt1 is up, line protocol is up
Hardware is GigEthernet, address is 0000.0076.544a (bia 0000.0076.544a)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual none
BPRU guard is disabled, ROOT protect is disabled
Link Error Dampening is Disabled
STP configured to OFF, priority is level0, MAC-learning is enabled
Flow Control is config disabled, oper enabled
Mirror disabled, Monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
IPG MII 0 bits-time, IPG GMII 0 bits-time
IP MTU 1500 bytes
300 second input rate: 83728 bits/sec, 130 packets/sec, 0.01% utilization
300 second output rate: 24 bits/sec, 0 packets/sec, 0.00% utilization
39926 packets input, 3210077 bytes, 0 no buffer
Received 4353 broadcasts, 32503 multicasts, 370 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants
22 packets output, 1540 bytres, 0 underruns
Transmitted 0 broadcasts, 6 multicasts, 16 unicasts
0 output errors, 0 collisions
To display the management interface information in brief form, enter the show interfaces brief
management command.
Syntax: show interfaces brief management num
device# show interfaces brief management 1
Port
mgmt1
To display management port statistics, enter the show statistics management command.
Syntax: show statistics management num
device# show statistics management 1
Port
mgmt1
Port mgmt1 Counters:
InBroadcastPkts
InMultiastPkts
InUnicastPkts
InBadPkts
InFragments
20
Link
State
Dupl
Up
None
Full
Link
State
Dupl
Up
None
Full
InOctets
3210941
InPkts
39939
OutPackets
4355
35214
370
0
0
Speed
Trunk
Tag
1G
None
Speed
Trunk
Tag
1G
None
OutOctets
1540
22
OutbroadcastPkts
OutMulticastPkts
OutUnicastPkts
16
Pri
MAC
Name
No
0
0000.0076.544a
Pri
MAC
Name
No
0
0000.0076.544a
0
6
FastIron Ethernet Switch Administration Guide
53-1003625-01

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FastIron and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF