Brocade Communications Systems FastIron Administration Manual page 262

Clearing sFlow statistics
TABLE 37
Parameter
exporting cpu-traffic
sample rate
exporting system-info
exporting system-info
polling interval
UDP packets exported
sFlow samples collected
sFlow ports
Module Sampling Rates
Port Sampling Rates
Clearing sFlow statistics
To clear the UDP packet and sFlow sample counters in the show sflow display, enter the following
command.
device#clear statistics
Syntax: clear statistics
This command clears the values in the following fields of the show sflow display:
• UDP packets exported
• sFlow samples collected
NOTE
This command also clears the statistics counters used by other features.
262
sFlow information (Continued)
Definition
The sampling rate for CPU-directed data, which is the average ratio of the number of
incoming packets on an sFlow-enabled port, to the number of flow samples taken from
those packets.
Indicates whether or not the sFlow agent is configured to export information about CPU
and memory usage to the sFlow collector:
• enabled
• disabled
Specifies the interval, in seconds, that sFlow data is sent to the sFlow collector.
The number of sFlow export packets the Brocade device has sent.
NOTE
Each UDP packet can contain multiple samples.
The number of sampled packets that have been sent to the collectors.
The ports on which you enabled sFlow.
The configured and actual sampling rates for each module. If a module does not have
any sFlow-enabled ports, the rates are listed as 0.
The configured and actual sampling rates for each sFlow-enabled port.
The Subsampling factor indicates how many times the sampling rate of the port's
module is multiplied to achieve the port's sampling rate. Because of the way the actual
sampling rates are computed, the Subsampling factors are always whole numbers.
FastIron Ethernet Switch Administration Guide
53-1003625-01