8.3.8
Finisher firmware (MJ-1031)
Important:
•
Be sure to shut down the equipment before installing and removing the download jig.
•
Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Update Procedure
(1)
Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2)
Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3)
Take off the hanging finisher (MJ-1031) from the equipment.
(4)
Take off the rear cover.
e-STUDIO205L/255/305/355/455
FIRMWARE UPDATING
Fig. 8-46
Fig. 8-47
© 2009 TOSHIBA TEC CORPORATION All rights reserved
8 - 44