Table of Contents
Advertisement
8.3.7
Finisher firmware (MJ-1031)
Important:
•
Be sure to shut down the equipment before installing and removing the download jig.
•
Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Update Procedure
(1)
Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2)
Press the [ON/OFF] button on the control panel to shut down the equipment.
(3)
Take off the hanging finisher (MJ-1031) from the equipment.
(4)
Take off the rear cover.
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Fig. 8-49
Fig. 8-50
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
8 - 51
FIRMWARE UPDATING
8
Advertisement
Table of Contents
