Toshiba e-STUDIO205L Service Handbook page 191

Classific
Code
ation
5001-0 Image Print job end cleaning
processi bias polarity switching
ng frequency
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Setting mode (08)
Functi
Items <Acceptable
on
ALL
2 - 163
Default
Boa
Contents
rd
value>
0 M In the cleaning
<0-9> operation of the transfer
roller at the end of
printing, the cleaning
bias, in which the
polarity is switched from
positive to negative, is
output so that the toner
adhering to the transfer
roller is returned to the
photoconductive drum.
This code is used to set
the cleaning bias
switching frequency.
Perform adjustment
when there is any stain
on the back side of the
printed paper (leading
edge) caused by the
transfer roller.
Note that the drum
driving time will
increase if the setting
value of the cleaning
bias switching
frequency is too large.
The setting code differs
depending on the
operation status of the
equipment when there
is any stain on the back
side of the printed
paper. Select the code
from 5001 to 5003
according to the
operation status.
Set this code when
there is any stain on the
back side of the printed
paper (leading edge)
caused by the transfer
roller in normal printing.
0: Once
1: Twice
2: Three times
3: Four times
4: Five times
5: Six times
6: Seven times
7: Eight times
8: Nine times
9: Ten times
e-STUDIO205L/255/305/355/455
Proce
dure
4
SELF-DIAGNOSIS MODES
2