Adjustment Of Image Density - Toshiba e-STUDIO205L Service Handbook

3.7.2

Adjustment of image density

The image density level can be set at the following codes.
Code
678-0 to 4 Adjustment of image density
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the code and press the [START] button.
(3) Key in the sub code and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5) Press the [ENTER] or [INTERRUPT] button to store the value in memory. The equipment goes
back to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Turn the power OFF.
<Confirmation>
If possible, perform a Fax transmission and check the adjusted density with the image on the recipient's
side.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Item to be adjusted
3 - 39
< Adjustment Mode (05) >
Remarks
When the value is decreased, text becomes lighter.
Acceptable values: 0 to 10
Notes:
1. Set not to reverse the large and small
number of the setting value corresponding
to the sub code.
Ex.) When the image density level for 667-0,
678-1, 678-2, 678-3, and 678-4 is assumed
to be "A","B", "C", "D", and "E" respectively,
they should have the following correlation:
A B C D E
2. Remember that the image specifications
and life span of the replacing parts may not
meet the standard when the setting value is
changed from the default value.
e-STUDIO205L/255/305/355/455
ADJUSTMENT
3