Replacemant Of Hdd/Pc Boards - Toshiba e-STUDIO205L Service Handbook

Hide thumbs Also See for e-STUDIO205L:

Table of Contents

REPLACEMANT OF HDD/PC BOARDS

Precautions and Procedures for Replacing PC Boards and

Precautions when replacing PC boards

The ID for each equipment is registered on the LGC board, the IMG board, the SYS board and the

SLG board. So, if their replacement is required, be sure to replace only one board at a time.

If more than one of the LGC board, the IMG board and the SYS board require replacement, replace

them in the following procedure.

1. First, replace one of the board to be replaced.

2. Turn the power ON and confirm that "READY" is displayed.

3. Turn the power OFF.

4. Replace another board that requires replacement.

5. Repeat steps 2 to 4.

The IMG board can be replaced without other settings.

To replace the HDD, see the following procedure.

P.7-4 "7.1.3 Precautions and procedures when replacing the HDD"

To replace the SYS board, see the following procedure.

P.7-9 "7.1.4 Precautions and Procedures when replacing the SYS board"

To replace the LGC board, see the following procedure.

P.7-11 "7.1.5 Procedures when replacing the LGC board"

To replace the SLG board, see the following procedure.

P.7-11 "7.1.6 Procedures when replacing the SLG board"

To replace the SRAM board, see the following procedures.

P.7-12 "7.1.7 Precautions and Procedures when replacing SRAM board"

To replace the EEPROM, see the following procedures.

P.7-15 "7.1.8 Procedures when replacing EEPROM"

REPLACEMANT OF HDD/PC BOARDS

e-STUDIO205L/255/305/355/455

Show Quick Links

Table of Contents