Control Panel Check Mode (01) - Toshiba e-STUDIO205L Service Handbook

State transition diagram of self-diagnosis modes
Normal
[0][1]
Control panel
Warming up
check mode
Ready
[POWER]
OFF
*1
To user
*1. Turn OFF the power after using the self-diagnosis modes, and leave the equipment to the user.
2.1.1

Control panel check mode (01)

Operation procedure
[0][1]
[POWER] LCD blinking
The mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
Button Check
• Press the buttons with LED to turn OFF the LED.
• Press the buttons without LED to display the message on the control panel.
• Press the button on touch panel to display the screen on the control panel at power-ON.
Press [execution] on the touch panel and then the [CLEAR] button on the control panel. The screen
then returns to the Button Check menu.
2.1.2 Test mode (03)
Refer to the following.
P.2-4 "2.2 Input Check (Test Mode 03)"
P.2-12 "2.3 Output Check (Test Mode 03)"
2.1.3 Test print mode (04)
Refer to the following.
P.2-16 "2.4 Test Print Mode (Test Mode 04)"
2.1.4 Adjustment mode (05)
Refer to the following.
P.2-29 "2.6 Adjustment Mode (05)"
e-STUDIO205L/255/305/355/455
SELF-DIAGNOSIS MODES
[POWER]
ON
[0][3] [0][4] [0][5]
Adjustment
Test print
Test mode
mode
mode
LED lit/
[START]
[START]
[0][8] [9][START]
List print
Setting PM support
mode
mode
Fig. 2-1
(Button check)
© 2009 TOSHIBA TEC CORPORATION All rights reserved
2 - 2
[7][START] [8][9]/[4][9]
[6][START]
Firmware
EPU
update mode
mode replacement
mode
[POWER] OFF/ON
(Exit)