Toshiba e-STUDIO205L Service Handbook page 461

2. Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple
sheet slid from the staple case?
3. Is the connector J717 on the finisher controller PC board disconnected?
4. Is the harness connecting the finisher controller PC board and staple home position sensor
(PI50) open circuited?
5. Is the staple home position sensor working properly?
6. Reconnect or replace the connector of the staple home position sensor.
7. Replace the finisher controller PC board.
MJ-1031
1. Check if there is any paper in the finisher or stapler and remove it if there is.
2. Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple
sheet slid from the staple case?
3. Check if the connectors J112, J113 on the finisher controller PC board is disconnected from the
stapler) or the harnesses are open circuited. Correct if any.
4. Check if the connectors on the stapler is disconnected or the harnesses are open circuited.
Correct if any.
5. Replace the stapler.
6. Replace the finisher controller PC board.
MJ-1101
1. Check if there is any paper in the finisher or on the transport path of the equipment or on the
finishing tray. Remove it if there is.
2. Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple
sheet slid from the staple case?
3. Check if the actuator of the stapler interference sensor (S11) moves smoothly.
4. Check if the connector CN2 on the finisher controller PC board is disconnected from the stapler
or the harnesses are open circuited. Correct if any.
5. Check the harnesses in the stapler are disconnected or open circuited. Correct if any.
6. Replace the finisher controller PC board.
[EA60] Early arrival jam
MJ-1024
1. Check if there is any paper in the finisher or on the transport path of the equipment or on the
stapling tray. Remove it if there is.
2. Check if the connector on the finisher controller PC board is disconnected from the inlet sensor
(P133) or the harnesses are open circuited. Correct if any.
3. Check if the inlet sensor (P133) is working (or if the actuator returns) properly.
4. Replace the inlet sensor.
5. Replace the finisher controller PC board.
MJ-1031
1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it
if there is.
2. Check if the connector J104 on the finisher controller PC board is disconnected from the inlet
sensor (SR2) or the harnesses are open circuited. Correct if any.
3. Is the inlet sensor working properly? (Check the movement of the actuator.)
4. Replace the inlet sensor.
5. Replace the finisher controller PC board.
MJ-1101
1. Check if there is any paper in the finisher or on the transport path of the equipment or on the
finishing tray. Remove it if there is.
2. Check if there is any disconnection, incorrect installation or breakage on the entrance sensor
(S1). Correct if any.
3. Check if the connector CN7 on the finisher controller PC board is disconnected from the
entrance sensor (S1) and the harnesses are disconnected or open circuited. Correct if any.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 57
e-STUDIO205L/255/305/355/455
6