Toshiba e-STUDIO205L Service Handbook page 446

Is the PFP lower drawer feed clutch working?
(Perform the output check in the test mode: 03-228)
l NO
l
l
l
l
l
l
l
l
l
l
YES
Check the PFP lower drawer feed roller, separation roller and pickup roller.
Replace them if they are worn out.
e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
1. Check if the connector of the PFP lower drawer feed clutch is
disconnected.
2. Check if any of the connectors CN241 and CN248 on the PFP board
is disconnected.
3. Check if the connector CN318 on the LGC board is disconnected.
4. Check if the connector pins are disconnected and the harnesses are
open circuited.
5. Check if the conductor patterns on the PFP board and LGC board
are short circuited or open circuited.
6. Replace the PFP lower drawer feed clutch.
7. Replace the PFP board.
8. Replace the LGC board.
6 - 42
© 2009 TOSHIBA TEC CORPORATION All rights reserved