[B] Adjusting carriages-1 and -2 positions
<Procedure>
(1)
Move the carriage-2 toward the exit side.
(2)
Loosen the screws fixing the front side pulley bracket, make the sections A and B of the carriage-
2 touch with the inside of the exit side frame and screw them up.
[Rear]
(3)
Put the carriage-1 on the rail, make the sections C and D of it touch with the inside of the exit
side frame and screw up the front/rear sides of the bracket to fix it.
Note:
Make sure that the sections A and B of the carriage-2 touch with the exit side frame.
[Rear]
Bracket
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Carriage-2
B
Fig. 3-32
Carriage-1
Fig. 3-33
3 - 49
Pulley bracket
[Front]
Exit side frame
A
[Front]
Exit side frame
Bracket
e-STUDIO205L/255/305/355/455
3
ADJUSTMENT