Toshiba e-STUDIO205L Service Handbook page 507

[F106] Point and Print partition damage
(1) Turn the power OFF and start up the Setting Mode (08).
(2) Key in "662" and press the [START] button. (Partition clearing is performed.)
(3) Restart the equipment.
(4) Access TopAccess. Click the [Administration] tab, and then click the Maintenance Menu to open.
Then install the "Point and Print" driver.
[F107] /SHR partition damage
Initialize the Electronic Filing using the Setting Mode (08-666).
[F108] /SHA partition damage
Initialize the shared folder using the Setting Mode (08-667).
[F120] Database abnormality
(1) Rebuild the databases. (Perform 08-684.)
(2) If the error is not recovered, initialize the HDD. (Key in "2" at 08-690.)
[F130] Invalid MAC address
Compare the serial number of the equipment with a number displayed in 08-995. If they are different,
enter the correct serial number at 08-995.
[F200] Data overwrite option (GP-1070) disabled
Perform firmware installation (any of OS, HDD, system firmware, PFC firmware, main firmware engine
ROM and scanner firmware) using USB media.
* When the function of the Data Overwrite option (GP-1070) is deleted from the equipment, the
service call "F200" occurs.
[F350] SLG board abnormality
(1) Check if the conductor pattern on the SLG board is short circuited or open circuited.
(2) If there is no problem found in the check (1) above, check the combination of the firmware
version of the system ROM, engine ROM and scanner ROM. Reinstall the scanner ROM
firmware.
(3) If an error occurs after step (2) above has been performed, replace the SLG board.
[F400] SYS/HDD cooling fan abnormality
(1) Check if the fan is rotating properly.
(2) If not, check if any foreign object is adhered.
(3) Is the connector CN112 of the SYS board connected securely?
(4) Replace the SYS/HDD cooling fan.
(5) Replace the SYS board.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 103
e-STUDIO205L/255/305/355/455
6