Toshiba e-STUDIO205L Service Handbook page 411

Error code Classification
EA80 Finisher jam
(Saddle Stitcher
section)
EA90
EAA0
EAB0
EAC0
EAD0 Other paper jam
EAE0 Finisher jam
EB30
EB50 Paper transport jam
EB60
ED10 Finisher jam
ED11
ED12
ED13
ED14
ED15
ED16
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Contents
Stapling jam: Stapling is not performed properly.
[MJ-1024]
Door open jam: The delivery cover or inlet cover
has opened during printing [MJ-1024/MJ-1101].
Power-ON jam: Paper exists at No.1 paper sensor,
No. 2 paper sensor, No.3 paper sensor, vertical
path paper sensor or delivery sensor when power is
turned ON. [MJ-1024/MJ-1101]
Saddle paper transport stop jam: The paper which
passed through the inlet sensor does not reach or
pass through the folding position sensor. [MJ-1025]
Saddle transport delay jam: The paper which has
reached the inlet sensor does not pass through this
sensor. [MJ-1025/MJ-1024]
Print end command time-out jam: The printing has
not finished normally because of the
communication error between the SYS board and
LGC board at the end of printing.
Receiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the
finisher.
Ready time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
Skew adjustment motor home position detection
abnormality: The Skew adjustment motor is not at
the home position. [MJ-1101 (when MJ-6101 is
installed)]
Sideways adjustment motor home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101 (when MJ-6101
is installed)]
Shutter home position error: The shutter is not at
the home position. [MJ-1101]
Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101]
Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101]
Paddle home position error: The paddle is not at the
home position. [MJ-1101]
Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101]
6 - 7
Troubleshooting
P. 6-59
P. 6-59
P. 6-59
P. 6-60
P. 6-61
P. 6-62
P. 6-62
P. 6-62
P. 6-36
P. 6-37
P. 6-62
P. 6-62
P. 6-63
P. 6-63
P. 6-63
P. 6-63
P. 6-63
e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6