Toshiba e-STUDIO205L Service Handbook page 467

[ED12] Shutter home position error
MJ-1101
1. Open and close the shutter. If there is any mechanical problem, fix its mechanism.
2. Check if the connectors on the finisher controller PC board are disconnected from the shutter
opening/closing sensor (S4) and the shutter clutch (CLT1), or the harnesses are open circuited.
Correct if any.
3. Replace the shutter clutch (CLT1).
4. Replace the shutter opening/closing sensor (S4).
5. Replace the finisher controller PC board.
[ED13] Front alignment plate home position error
MJ-1101
1. Move the front alignment plate. If there is any mechanical problem, fix its mechanism.
2. Check if the connectors on the finisher controller PC board are disconnected from the front
alignment plate home position sensor (S7) and the front alignment motor (M9), or the harnesses
are open circuited. Correct if any.
3. Replace the front alignment motor (M9).
4. Replace the front alignment plate home position sensor (S7).
5. Replace the finisher controller PC board.
[ED14] Rear alignment plate home position error
MJ-1101
1. Move the rear alignment plate. If there is any mechanical problem, fix its mechanism.
2. Check if the connectors on the finisher controller PC board are disconnected from the rear
alignment plate home position sensor (S8) and the rear alignment motor (M10), or the harnesses
are open circuited. Correct if any.
3. Replace the rear alignment motor (M10).
4. Replace the rear alignment plate home position sensor (S8).
5. Replace the finisher controller PC board.
[ED15] Paddle home position error
MJ-1101
1. Rotate the paddle. If there is any mechanical problem, fix its mechanism.
2. Check if the connectors on the finisher controller PC board are disconnected from the paddle
home position sensor (S3) and the paddle motor (M8), or the harnesses are open circuited.
Correct if any.
3. Replace the paddle motor (M8).
4. Replace the paddle home position sensor (S3).
5. Replace the finisher controller PC board.
[ED16] Buffer tray home position error
MJ-1101
1. Open and close the buffer tray guide. If there is any mechanical problem, fix its mechanism.
2. Check if the connectors on the finisher controller PC board are disconnected from the buffer tray
home position sensor (S5) and the buffer tray guide motor (M3), or the harnesses are open
circuited. Correct if any.
3. Replace the buffer tray guide motor (M3).
4. Replace the buffer tray home position sensor (S5).
5. Replace the finisher controller PC board.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 63
e-STUDIO205L/255/305/355/455
6