Toshiba e-STUDIO205L Service Handbook page 552

[D] Erase HDD
When the Data Overwrite Enabler (GP-1070) is installed, be sure to perform 08-1426 (forcible HDD
data clearing) and confirm that deleting of the HDD data is completed.
P.7-16 "7.2.1 Precautions for Installation of GP-1070 and Disposal of HDD/Board"
[E] Replace / Format HDD
(1) Confirm that the main power switch is turned OFF.
(2) Replace the HDD. For the details, see the following page.
Service Manual Chap.2
(3) Clear the partitions on the HDD.
1. Turn the power ON while pressing [3] and [CLEAR] button simultaneously.
2. When "Firmware Assist Mode" appears on the LCD, key in [3] to select "3: All Partition
Delete and Create Loader Partition." and then press the [START] button.
3. When "Initialize completed." is displayed on the LCD, clearing of the partitions is completed.
(4) Turn the power OFF.
(5) Update the master data using the USB media.
P.8-5 "8.1 Firmware Updating with USB Media"
(6) Start up with the Setting Mode (08).
(7) Format the HDD (08-690).
• When "REBOOT THE MACHINE" is displayed on the LCD, formatting of the HDD is
completed.
(8) Turn the power OFF.
(9) When the Fax Unit (GD-1250) is installed, perform "Fax Set Up" (1*-100) and "Clearing the
image data" (1*-102).Then turn the power OFF.
(10) Start up with the Setting mode (08).
(11) Check the version of the HDD (08-944).
• Confirm the version displayed on the LCD, and then press the [ENTER] button.
(12) Turn the power OFF.
e-STUDIO205L/255/305/355/455
REPLACEMANT OF HDD/PC BOARDS
© 2009 TOSHIBA TEC CORPORATION All rights reserved
7 - 6