(10) In the FAX Clearing Mode, perform the "FAX Set Up".
•
Confirm the destination setting is correct in the Setting Mode (08).
08-201: Destination setting of the equipment
08-701: Destination setting of the FAX machine
•
Turn the power ON using the main power switch while [1] button and [*] button are pressed
simultaneously.
•
Key in "100".
•
Press the [START] button.
Notes:
If the equipment does not work properly after the operation (8), follow the procedure below and
then perform the "Clearing the image data" in the FAX Clearing Mode to erase the image data in
the memory.
•
Confirm the destination setting is correct in the Setting Mode (08).
08-201: Destination setting of the equipment
08-701: Destination setting of the FAX machine
•
Turn the power ON using the main power switchr while [1] button and [*] button are pressed
simultaneously.
•
Key in "102".
•
Press the [START] button.
[B] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
P.8-50 "8.4 Confirmation of the updated data"
© 2009 TOSHIBA TEC CORPORATION All rights reserved
8 - 49
e-STUDIO205L/255/305/355/455
FIRMWARE UPDATING
8