Image Dimensional Adjustment - Toshiba e-STUDIO205L Service Handbook

3.3

Image Dimensional Adjustment

3.3.1 General description
There are several adjustment items in the image dimensional adjustment, as listed below. When
adjusting these items, the following adjustment order should strictly be observed.
1 Paper alignment at the registration roller
2 Printer related (a) Reproduction ratio of primary scanning direction
adjustment
(b) Primary scanning data laser writing start position
(c) Reproduction ratio of secondary scanning
(d) Secondary scanning data laser writing start
(e) Primary scanning data laser writing start position
3 Scanner related (a) Image distortion
adjustment
(b) Reproduction ratio of primary scanning direction
(c) Image location of primary scanning direction
(d) Reproduction ratio of secondary scanning
(e) Image location of secondary scanning direction
(f) Top margin
(g) Right margin
(h) Bottom margin
e-STUDIO205L/255/305/355/455
ADJUSTMENT
Item to be adjusted
(Fine adjustment of polygonal motor rotation
speed)
direction
(Fine adjustment of main motor rotation speed)
position
at duplexing
direction
© 2009 TOSHIBA TEC CORPORATION All rights reserved
3 - 4
Code in mode 05
448, 449, 450, 452, 455, 457,
458, 460, 461, 462, 463, 469,
470, 471, 472, 473, 474
401
411
421
441, 440, 444, 443, 442, 445
498
–
405
306
340
305
430
432
433