Diagnosis And Prescription For Each Error Code - Toshiba e-STUDIO205L Service Handbook

6.3

Diagnosis and Prescription for Each Error Code

6.3.1 Paper transport jam
[E010] Leading edge of paper not reaching the exit sensor
[E020] Trailing edge of paper not passing the exit sensor
Open the Automatic duplexing unit. Is there any paper on the transport path?
YES
NO
Is the exit sensor working? (Perform the input check in the test mode: 03-[FAX]ON/[9]/[B])
l NO
l
l
l
l
l
l
l
YES
Is the registration roller clutch working?
(Perform the output check in the test mode: 03-108/158)
l NO
l
l
l
l
l
l
l
l
YES
Check the registration roller. Replace it if it is worn out.
e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
Remove the paper.
1. Check if the connector of the exit sensor is disconnected.
2. Check if the connector CN309 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are
open circuited.
4. Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5. Replace the exit sensor.
6. Replace the LGC board.
1. Check if the connector of the registration roller clutch is
disconnected.
2. Check if the connector CN315 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are
open circuited.
4. Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5. Replace the registration roller clutch.
6. Replace the LGC board.
6 - 26
© 2009 TOSHIBA TEC CORPORATION All rights reserved