Adjustment Of Radf Height - Toshiba e-studio200l Service Handbook

3.10.2

Adjustment of RADF height

It is mainly performed at the installation. It is also required when the RADF is dislocated for some rea-
son such as moving the equipment.
Perform the following adjustment by using the screw of the left and right hinge.
Note: Note:
Perform this adjustment after "3.10.1 Adjustment of RADF position".
Turn the exposure lamp ON during the gap check. (Test Mode: 03-267)
<Procedure>
(1) Adjustment standard:
Adjust the height so that the platen guide front holder touches the ADF original glass.
Adjust the height so that the gap between the platen guide rear holder and the ADF original glass
becomes 0.5 mm ± 0.3.
Platen guide
rear holder
(2) Adjust the height by turning the height
adjusting screw on the right hinge.
CW: The height of the hinge becomes high.
CCW: The height of the hinge becomes low.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
Platen guide
front holder
ADF original glass
Fig. 3-62
3 - 58
Fig. 3-63
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved