Toshiba e-studio200l Service Handbook page 391

(3) Close the RADF and check if the positioning
pins fit the holes on the RADF.
[B] Adjustment
If the pins cannot be fitted into the holes, perform the adjustment according to the following procedure.
(1) Remove the right-hand hinge screw at the
rear side.
(2) Loosen the left-hand hinge screw at the rear
side.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Fig. 3-81
Fig. 3-82
Fig. 3-83
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
3 - 71
05/11
3
ADJUSTMENT