Toshiba e-studio200l Service Handbook page 151

Classifi-
Code
cation
615 General Size information of main
memory and page memory
617 User Print setting without
interface department code
618 User Default setting when mixed
interface size originals are set on
RADF
619 Paper Time lag before Auto Job
feeding Start of bypass feeding
620 User Department management
interface setting (Copier)
621 User Department management
interface setting (FAX)
622 User Department management
interface setting (Printer)
623 User Department management
interface setting (Scanner)
624 User Department management
interface setting (List print)
625 User Blank copying prevention
interface mode during RADF jam-
ming
627 User Rotation printing at the
interface non-sorting
628 User Direction priority of original
interface image
629 User Department management
interface setting
633 Data Releasing F200 service
overwrite call
kit
634 User Inner receiving tray priority
interface at Non-sort Mode
636 User Width setting for image
interface shift copying (linkage of
front side and back side)
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Setting mode (08) <e-STUDIO200L/230/230L/280>
Func-
Items
tion
ALL
ALL
PPC
ALL
PPC
FAX
PRT
SCN
PRT
PPC
ALL
PPC
ALL
ALL
ALL
PPC
2 - 115
09/01
Default
<Accept-
RAM Contents
able
value>
- SYS Displays the sizes of
the main memory and
page memory. Enables
to check if each mem-
ory is properly recog-
nized.
0 SYS 0: Printed
<0-1> 1: Not printed
0 SYS 0: Scanned as all in
<0-1> same size
1: Scanned as each
original size
4 SYS Sets the time taken to
<0-10> add paper feeding
when paper in the
bypass tray has run out
during the bypass feed
copying.
0: No delay
1-10: Setting value x
0.5 sec.
1 SYS 0: Invalid
<0-1> 1: Valid
1 SYS 0: Invalid
<0-1> 1: Valid
1 SYS 0: Invalid
<0-1> 1: Valid
1 SYS 0: Invalid
<0-1> 1: Valid
1 SYS 0: Invalid
<0-1> 1: Valid
0 SYS 0: OFF
<0-1> 1: ON (Start printing
when the scanning
of each page is fin-
ished)
0 SYS 0: Not rotating
<0-1> 1: Rotating
0 SYS 0: Automatic
<0-1> 1: Portrait
0 SYS 0: Invalid
<0-1> 1: Valid
0 SYS 0: Not used
<0-2> 1: Board installed
(GP-1050)
2: Service call
0 SYS 0: Normal
<0-1> 1: Inner receiving tray
0 SYS 0: ON
<0-1> 1: OFF
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ERROR CODE AND SELF-DIAGNOSTIC MODE
Proce-
dure
2
2
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1