[H] Bottom margin
<Procedure>
(1)
While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
(2)
Open platen cover or RADF.
(3)
Press the [FAX] to make a copy at the mode of A3/LD, 100%, Text/Photo and standard drawer of
the equipment (Refer to *).
* Perform 08-477 and check the value.
If the value is 0, use the lower drawer.
If the value is 1, use the upper drawer.
(4)
Measure the blank area G at the trailing edge of the copied image.
(5)
Check if the blank area G is within the range of 2±1.0 mm.
(6)
If not, use the following procedure to change values and repeat the steps (3) to (5) above.
(Adjustment Mode) (Key in the code [433]) [START]
(Key in value (acceptable values: 0 to 255))
Press the [ENTER] or the [INTERRUPT] button (stored in memory).
("100% A" is displayed.)
* The larger the adjustment value is, the wider the blank area at the trailing edge becomes
(approx. 0.04 mm/step).
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
Feeding direction
G
Fig. 3-18
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
3 - 20
04/09