E-Studio202L/203L/232/233/282/283 - Toshiba e-studio200l Service Handbook

Hide thumbs Also See for e-studio200l:

Table of Contents

e-STUDIO202L/203L/232/233/282/283

[A] Assist Mode

This equipment has the Assist Mode to enable the following functions.

NVRAM flag clearing ("Clear NvRAM flags.")

Even if the firmware downloading has been completed normally, the Recovery Mode may acci-

dentally start up when the power is turned ON again. In this case, clear the NVRAM flags used in

the download process with this function. (Normally, the flags are automatically cleared in the

download process.)

Also in the case the Recovery Mode accidentally starts up after the replacement of NVRAM on

the SYS board, the flags are cleared with this function.

Data storage partition formatting ("Format Loader Partition.")

When a defection occurs on the UI data, etc. which are stored in the HDD, the partition with the

stored UI data, etc. is formatted with this function. (Do not use this function since it is not nor-

mally necessary.)

HDD partition creation ("All Partition Delete and Create Loader Partition.")

When the HDD is replaced or UI data, etc. are downloaded using the USB storage, it is neces-

sary to format a partition in the HDD before downloading. In this case, the partition is created in

the HDD with this function.

1. When downloading with a download jig, it is not necessary to format a partition in advance.

2. Perform the HDD partition formatting only when a new HDD and scrambler board are installed

since all data in the current HDD are erased by this operation.

[B] Operating Procedure of Assist Mode

Turn ON the power while [3] button and [CLEAR] button are pressed simultaneously.

The following screen is displayed.

Select the item with the digital keys and press the [START] button.

e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283

FIRMWARE UPDATING

Show Quick Links

Table of Contents