Toshiba e-studio200l Service Handbook page 460

[E320] Paper fed from the PFP upper drawer not reaching the 2nd transport sensor
[E350] Paper fed from the PFP lower drawer not reaching the 2nd transport sensor
[E3E0] Paper fed from the LCF not reaching the 2nd transport sensor
Open the side cover. Is there paper in front of the 2nd transport sensor?
YES  Remove the paper.

NO
Is the 2nd transport sensor working?
(Perform the input check in the test mode: 03-[FAX]OFF/[7]/[E]
l NO 
l
l
l
l
l
l
l

YES
Are the (lower/middle) transport clutches working?
(Perform the output check in the test mode: 03-203, 205)
l NO 
l
l
l
l
l
l
l
l

YES
Is the PFP transport clutch working? (Perform the output check in the test mode: 03-225)
l NO 
l
l
l
l
l
l
l
l
l
l

YES
1) Check the condition of the feed roller, separation roller and pickup roller of each paper
source, and replace them if they are worn out.
2) Check the transport roller. Replace it if it is worn out.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
1) Check if the connector of the 2nd transport sensor is disconnected.
2) Check if the connector CN304 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the 2nd transport sensor.
6) Replace the LGC board.
1) Check if the connectors of the (lower/middle) transport clutches are
disconnected.
2) Check if the connector CN305 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the (lower/middle) transport clutches.
6) Replace the LGC board.
1) Check if the connector of the PFP transport clutch is disconnected.
2) Check if any of the connectors CN241, CN242 and CN244 on the
PFP board is disconnected.
3) Check if the connector CN310 on the LGC board is disconnected.
4) Check if the connector pins are disconnected and the harnesses are
open circuited.
5) Check if the conductor patterns on the PFP board and LGC board
are short circuited or open circuited.
6) Replace the PFP transport clutch.
7) Replace the PFP board.
8) Replace the LGC board.
5 - 6
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved