Error Code And Self-Diagnostic Mode - Toshiba e-studio200l Service Handbook

2.

ERROR CODE AND SELF-DIAGNOSTIC MODE

2.1 Error Code List
One of the following error codes is displayed at the upper right of the screen while pressing the
[CLEAR] button and the digital key [8] simultaneously when the "CLEAR PAPER" or "CALL SER-
VICE" symbol is blinking.
2.1.1 Jam
Error code Classification
E010 Paper exit jam
E020
E030 Other paper jam
E061
E062
E063
E064
E065
E090
E110 Paper misfeeding
E120
E130
E140
E150
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Contents
Jam not reaching the exit sensor: The paper which
has passed through the fuser unit does not reach
the exit sensor.
Stop jam at the exit sensor: The trailing edge of the
paper does not pass the exit sensor after its leading
edge has reached this sensor.
Power-ON jam: The paper is remaining on the
paper transport path when power is turned ON.
Incorrect paper size setting for upper drawer: The
size of paper in the 1st drawer differs from size set-
ting of the equipment.
Incorrect paper size setting for lower drawer: The
size of paper in the 2nd drawer differs from size set-
ting of the equipment.
Incorrect paper size setting for PFP upper drawer:
The size of paper in the 3rd drawer differs from size
setting of the equipment.
Incorrect paper size setting for PFP lower drawer:
The size of paper in the 4th drawer differs from size
setting of the equipment.
Incorrect paper size setting for bypass tray: The
size of paper in the bypass tray differs from size
setting of the equipment.
HDD abnormality causes jam: Image data to be
printed cannot be prepared.
ADU misfeeding (Paper not reaching the 1st trans-
port sensor): The paper which has passed through
ADU does not reach the 1st transport sensor during
duplex printing.
Bypass misfeeding (Paper not reaching the 1st
transport sensor): The paper fed from the bypass
tray does not reach the 1st transport sensor.
Upper drawer misfeeding (Paper not reaching the
1st transport sensor): The paper fed from the upper
drawer does not reach the 1st transport sensor.
Lower drawer misfeeding (Paper not reaching the
2nd transport sensor): The paper fed from the lower
drawer does not reach the 2nd transport sensor.
PFP upper drawer misfeeding (Paper not reaching
the PFP upper drawer feed sensor): The paper fed
from the PFP upper drawer does not reach the PFP
upper drawer feed sensor.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
2 - 1
06/09
Troubleshooting
P. 5-1
P. 5-1
P. 5-2
P. 5-2
P. 5-2
P. 5-2
P. 5-2
P. 5-2
P. 5-3
P. 5-15
P. 5-16
P. 5-17
P. 5-18
P. 5-19
ERROR CODE AND SELF-DIAGNOSTIC MODE
2