Toshiba e-studio200l Service Handbook page 636

<Updating Finisher ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct (P.6-33 "Fig. 6-35").
(2) Turn OFF the power of the equipment.
(3) Take off the finisher rear cover.
* Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
(5) Change the setting of he DIP switch on the finisher control PC board.
Change all the setting of the DIP switch (1-8) to OFF.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
FIRMWARE UPDATING
Finisher rear cover
Fig. 6-60
Connector
Fig. 6-61
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
6 - 56
05/11