Toshiba e-studio200l Service Handbook page 529

[CDE0] Paddle motor abnormality
MJ-1025
Is the paddle home position sensor (PI2) working properly?
NO 

YES
Is the Swing guide home position sensor (PI3) working properly?
NO 

YES
Is the wiring between the finisher controller PC board and Paddle motor (M2) correct?
NO 

YES
Try to rotate the paddle motor (M2) clockwise and counterclockwise by hand. Is there
mechanical trapping in the rotation of the paddle or the up/down movement of the swing
guide?
YES  Fix the mechanism.

NO
1) Replace the paddle motor (M2)
2) Replace the finisher controller PC board.
[CE00] Communication error between finisher and puncher unit
MJ-1025
Is the problem solved by turning the power of the equipment OFF and ON?
YES  End.

NO
Is the wiring between the finisher controller PC board and the punch controller PC board
correct?
NO 

YES
Measure the voltage between CN14-5 (+) and CN14-3 (-) on the finisher controller PC
board 24 V?
NO 

YES
Replace the punch controller PC board.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Replace the sensor.
Replace the sensor.
Correct the wiring.
Correct the wiring.
Replace the finisher controller PC board.
5 - 75
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
5