Toshiba e-studio200l Service Handbook page 490

[ 2 ] Paper jam in puncher unit
[E9F0] Punching jam
MJ-1025
Is there any paper remaining on the transport path in the finisher or equipment?
YES  Remove the paper.

NO
Is the connector J1006 on the punch controller PC board disconnected?
Is the harness connecting the punch controller PC board and punch home position sensor
(PI1P) open circuited?
YES  Connect the connector securely. Replace the harness.

NO
Is the punch home position sensor working properly?
l NO 

YES
Replace the punch controller PC board.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
1) Connect the connector of the punch home position sensor securely.
2) Replace the punch home position sensor.
5 - 36
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved