Configuring Network Settings (Configuration > Configure Network Settings) - HP StoreEver MSL2024 User And Service Manual

Hide thumbs Also See for StoreEver MSL2024:
Table of Contents

Advertisement

Use Set Date and Time to set the date and time used to record events. Access to this feature
requires the administrator password.
To set the date:
1.
From the Home screen, press Previous or Next until the screen displays Configuration.
Press Enter to select.
2.
Press Previous or Next until the screen displays Library Date/Time. Press Enter to select.
3.
Enter the administrator password if prompted.
4.
The screen displays Set Yr/Month/Day 2012 / 07 / 21 with a flashing number. Press Previous
or Next to change the value of the flashing number. Press Enter to accept the value of the
flashing number and move to the next number.
5.
Repeat Step 4 until all numbers in the date are correct. Press Enter.
6.
The screen displays (example) Set Hour / Mins 16 : 52 with the first number flashing. Press
Previous or Next until the flashing number reads correctly. Press Enter to move to the next
number. Repeat this step until all numbers in the time are correct. Press Enter.
Configuring network settings (Configuration > Configure Network Settings)
The device can automatically obtain an IP address from a DHCP server when the device is
powered on. The device also supports user-specified fixed addresses through the front panel.
The device also supports SNMP. You can enable SNMP and configure the target addresses with
the RMI. See
To configure IPv4 network settings:
1.
From the Home screen, press Previous or Next until the screen displays Configuration.
Press Enter to select.
2.
Press Previous or Next until the screen displays Configure Network Settings. Press Enter
to select.
3.
Press Previous or Next until the screen displays IPv4 Networking Enabled. Press Enter
to select.
4.
Press Previous or Next until the screen displays DHCP Enabled. To change the setting,
press Enter. Press Next until the screen shows the desired setting. Press Enter to accept
the new setting.
5.
If DHCP is disabled, press Previous or Next until the screen displays IP Address. The
second line displays the current IP address.
6.
To change the IP address, press Enter. The screen displays Set IP Address with the first
number flashing. Press Previous or Next to change the flashing number to the correct value.
7.
Press Enter to select the next number, until all numbers have been set. The screen displays
New IP Address.
8.
Press Previous or Next until the screen displays Subnet Mask Address. To change the
Subnet Mask Address, press Enter. The screen displays Set Subnet Mask Address, with
the first number flashing.
9.
Press Previous or Next to change the flashing number to the correct value. Press Enter to
select the next number.
10. Repeat Step 9 until all numbers have been set. The screen displays New Subnet Address.
11. Press Previous or Next until the screen displays Gateway Address. To change the Gateway
Address, press Enter. The screen displays Set Gateway Addr, with the first number flashing.
12. Press Previous or Next to change the flashing number to the correct value. Press Enter to
select the next number.
13. Repeat Step 12 until all numbers have been set. The screen displays New Gateway Addr.
Press Enter.
To enable IPv6:
1.
From the Home screen, press Previous or Next until the screen displays Configuration.
Press Enter to select.
"Changing the network configuration" (page
73).
Using the MSL2024 OCP 101

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storeever msl4048Storeever msl8048Storeever msl8096

Table of Contents