HP StoreEver MSL2024 User And Service Manual page 195

Figure 104 Removing the old power supply
3. Position the new power supply on the alignment rails and slide it into the library until it is
flush with the back panel, as shown in
thumbscrews to secure the power supply.
Figure 105 Installing the new power supply
4. Attach an AC power cord to the replaced power supply and plug into a power outlet. Power
on the tape library, if necessary.
5. Verify that the new power supply is operating properly. On a power supply with LEDs, the
blue and green LEDs on the power supply module should be lit and the yellow LED should
be off. See Figure 106 (page
the OCP does not show a warning message about the power supply.The blue and green
LEDs on the power supply module should be lit and the yellow LED should be off. See
Figure 106 (page
Figure 106 Power supply LEDs
1. Blue AC power is connected.
2. Yellow Fan failure. The fan is running too slow or is defective.
3. Green The power supply is producing good power for the library.
Figure 105 (page
195). Otherwise, verify that the power supply fan is running and
195).
Replacing the power supply (MSL4048, MSL8048, and MSL8096) 195
195). Tighten the three blue