Using The Manual Magazine Release; Installing A Redundant Power Supply (Msl4048, Msl8048, And Msl8096 Only) - HP StoreEver MSL2024 User And Service Manual

Hide thumbs Also See for StoreEver MSL2024:
Table of Contents

Advertisement

Using the manual magazine release

1.
From the back of the library determine which magazine needs to be removed using
magazine release holes" (page
holes on the bottom tape drive plate. For the MSL4048, MSL8048, and MSL8096, the library
will release all magazines on a side at the same time.
Figure 99 Manual magazine release holes
1.
2.
2.
Push a small metal pin or paper clip about 1.5 cm (0.6 inch) into the appropriate release
hole to push on the release latch (see
the magazine and removes it from the library.
Figure 100 Removing the left magazine
1.
2.
IMPORTANT:
the library.
Installing a redundant power supply (MSL4048, MSL8048, and MSL8096
only)
The MSL4048, MSL8048, and MSL8096 Tape Libraries have an optional redundant power supply
system, which allows the library to continue operating when one power supply fails. With the
redundant power supply system, the library can monitor the status of each power supply and
power supply fan. The redundant power supply can be installed without powering off the library.
192 Upgrading and servicing the tape library
192). The magazines are released from the magazine release
Right magazine release
Left magazine release
Insert a pin into access hole
Release and remove the magazine
Do not force the pin once you encounter resistance. Doing so can damage
Figure 100 (page
192)) while another person grasps
"Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storeever msl4048Storeever msl8048Storeever msl8096

Table of Contents