Changing The Scsi Address - Parallel Scsi Drives (Configuration> Change Drive); Changing The Drive Configuration - Fibre Channel Drives (Configuration> Change Drive) - HP StoreEver MSL2024 User And Service Manual

label 12345678, if alignment is left, the device will report 123456. If alignment is right, the device
will report 345678. The maximum length is 15 characters. The default configuration is 8 Left.
The OCP displays bar code labels longer than eight characters in an abbreviated form. Access
to this feature requires the administrator password.
To configure the bar code report format:
1. From the Home screen, press Previous or Next until the screen displays Configuration.
Press Enter to select.
2. Press Previous or Next until the screen displays Barcode Format Reporting. Press Enter
to select.
3. Press Previous or Next until the screen displays either Display Format or Host Format.
The second line displays the number of characters and the current format. To change the
current format, press Enter to select either Display or Host. An example of the screen
display is # of characters 8.
4. Press Previous or Next until the desired number of characters is listed. Press Enter to
select.
5. The screen displays either Alignment Left or Alignment Right. Use Previous or Next to
toggle between the two choices. Press Enter to select the correct alignment.
Changing the SCSI address — parallel SCSI drives (Configuration> Change Drive)
CAUTION:
reconfigure your backup software before you can use the device.
This option changes the SCSI address of a tape drive. The tape drive logical unit number (LUN)
will always be LUN 0 on the SCSI address. The library SCSI address will be the same as the
master drive, but will use LUN 1. Access to this feature requires the administrator password.
To change the drive SCSI address:
1. From the Home screen, press Previous or Next until the screen displays Configuration.
Press Enter to select.
2. Press Previous or Next until the screen displays Change Drive 1 or Change Drive 2.
Press Enter to select.
3. Enter the administrator password if prompted.
4. The screen displays the current SCSI ID. Press Previous or Next to change the SCSI ID
number. Press Enter to select. An example of the screen display is Drive 1 SCSI ID 6.
Changing the drive configuration — Fibre Channel drives (Configuration> Change Drive)
This option allows you to configure the FC ports for your tape drive.
Each drive has two ports, A and B.
NOTE: Hewlett Packard Enterprise recommends that you cable Port A only and that you
configure Port B for Auto Detect on Fibre Speed and Port Type.
To configure the FC settings:
1. From the Home screen, press Previous or Next until the screen displays Configuration.
Press Enter to select.
2. Press Previous or Next until the screen displays Change Drive 1. Press Enter to select.
3. Enter the administrator password if prompted.
4. The screen displays Port A. Press Enter to select and display Fibre Speed.
5. Press Enter to display Set Fibre Speed. Press Previous or Next to toggle through the
speed settings (Auto Detect, 1 Gb/s, 2 Gb/s, 4 Gb/s, or 8 Gb/s). Only speeds supported by
the drive are listed. Press Enter to select the required speed.
98 Operating the tape library
If you change the SCSI ID, you might need to cycle power on the host server and